Thingiverse
EUC Gotway Pedal Flipper
di damnagic
7
Download
9
Likes
0
Makes
A neat little pedal flipper I made for my Gotway wheels.
I thoroughly disliked the versions that use double sided tape or require elaborate attachment mechanisms. So, I had this idea for a design, thought it'd be too flimsy and after couple alterations I can say I was wrong and it works really well.
I've used this version for roughly 6 months and while they do break when making contact, they take just a couple minutes to print even at low speeds so it doesn't really matter.
It should definitely fit on MSX 21 and Mten3, but I reckon it'll fit just fine on all Gotway wheels and pedals if not even different brands as well.
Installation:
It's going to be a very very tight fit. I usually use a hammer for gentle, but purposeful taps when I install mine.
I thoroughly disliked the versions that use double sided tape or require elaborate attachment mechanisms. So, I had this idea for a design, thought it'd be too flimsy and after couple alterations I can say I was wrong and it works really well.
I've used this version for roughly 6 months and while they do break when making contact, they take just a couple minutes to print even at low speeds so it doesn't really matter.
It should definitely fit on MSX 21 and Mten3, but I reckon it'll fit just fine on all Gotway wheels and pedals if not even different brands as well.
Installation:
It's going to be a very very tight fit. I usually use a hammer for gentle, but purposeful taps when I install mine.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
