Thingiverse
EV Cable Hanger / Hook
by tcchan
4
Downloads
8
Likes
0
Makes
A simple design for a small issue. An EV charging cable hanger/hook to avoid cable getting ' dirty' while charging.
The print can take some time depending on the print speed of your printer. On a CR6-SE it took almost 12 hours to print (11:45). I had it also printed on a BambuLab P1S and it only took around 3 hours.
I advise using a brim to avoid possible warping with PETG, especially on a ' slow' printer. And (painted) support is only needed on the top part of the hook
The print can take some time depending on the print speed of your printer. On a CR6-SE it took almost 12 hours to print (11:45). I had it also printed on a BambuLab P1S and it only took around 3 hours.
I advise using a brim to avoid possible warping with PETG, especially on a ' slow' printer. And (painted) support is only needed on the top part of the hook
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
