Everest10 frame extension

This is an extension for the Redcat everest 10 chasis. If your like me and experience too much articulation, these will allow you to bring the shock into a more vertical position and stiffen it up.
This is a remix I did, took a section of an entire plate and reduced it to the extension so it can be printed on an ender 3. The original file was too large and couldnt be split.
I recommend laying this flat for the most strength, and printing it with PETG or ABS. PLA will work but does break easier.
100% infill
No supports
.2mm quality
increase to 5mm thickness for best results