Thingiverse
Evil Puzzle :(
von Fallout1964
51
Downloads
30
Likes
1
Makes
Remixed from: https://www.thingiverse.com/thing:4039896
Remodeled with an easy "print in place" hinge, now any printer can print this design if your slice height is 0.1mm - 0.2mm
Fixed the original design hinge not closing properly
Puzzle was difficult to open with strong magnets, so I added a thumb groove to assist.
Using the two magnets is VERY strong, try one at first.
Both Difficult and Evil puzzles are solvable.
Hint:- the 4 pieces only have to fit into the designated recess all at once.....they do not have to fill all the gaps !
Remodeled with an easy "print in place" hinge, now any printer can print this design if your slice height is 0.1mm - 0.2mm
Fixed the original design hinge not closing properly
Puzzle was difficult to open with strong magnets, so I added a thumb groove to assist.
Using the two magnets is VERY strong, try one at first.
Both Difficult and Evil puzzles are solvable.
Hint:- the 4 pieces only have to fit into the designated recess all at once.....they do not have to fill all the gaps !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
