Thingiverse
Evil Spool Hanger
von EvilTeach
6
Downloads
4
Likes
0
Makes
This holder is meant to be screwed into the wall above and behind your printer. Hang your spool on it and feed the line into your printer.
The holder has 4 screw pilot holes.
The post is wide enough to hold any of the spools that I have. If you have something wider, let me know.
Having the spools overhead makes it a lot easier to load the filament on my FFC dual.
Suggestions for improvements are gleefully accepted.
The holder has 4 screw pilot holes.
The post is wide enough to hold any of the spools that I have. If you have something wider, let me know.
Having the spools overhead makes it a lot easier to load the filament on my FFC dual.
Suggestions for improvements are gleefully accepted.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
