Thingiverse
Evolution Rage5s - Push Stick Holder
von ignisuti
3
Downloads
16
Likes
0
Makes
Friction fit holder for the Push Stick that comes with the Evolution Rage5s table saw.
Print vertically to avoid the need for supports.
To Install:
1.) Pop off the end cap on the far end of the fence.
2.) Slide this item through the grooves.
Note: Fits tightly against the top bolts of the fence to hold it in place.
Print vertically to avoid the need for supports.
To Install:
1.) Pop off the end cap on the far end of the fence.
2.) Slide this item through the grooves.
Note: Fits tightly against the top bolts of the fence to hold it in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!