Thingiverse
Evotech Rear Reflector Extension Bar
by Jackstacks
0
Downloads
0
Likes
0
Makes
I printed this to enable me to put the rear reflector on my bike without needing to drill into my small number plate. edge. This part allows you to join the plate fixings to the Evotech Rear Reflector.
Info:
Total Length: 121.97mm
Total Width: 25mm
Total height: 5mm
Single Hole Diameter: 8mm
Groove Diameter: 4mm
The single hole is designed to fix to the reflector and this is slightly smaller to prevent rubbing on the supports parts of the reflector plate.
The model printed a bit stringy, i need to dry out my PETG and reprint to get a smoother finish.
Info:
Total Length: 121.97mm
Total Width: 25mm
Total height: 5mm
Single Hole Diameter: 8mm
Groove Diameter: 4mm
The single hole is designed to fix to the reflector and this is slightly smaller to prevent rubbing on the supports parts of the reflector plate.
The model printed a bit stringy, i need to dry out my PETG and reprint to get a smoother finish.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!