Thingiverse
EWI mouthpiece Cap
door kkamagi
0
Downloads
0
Likes
0
Makes
This is a Mouthpiece Cap for Ewi wind controller. (Ewi USB, Ewi 4000s, Ewi 5000, Ewi Solo....)
It may vary depending on the printer's tolerance. If it is too stiff, printing at around 101% should be sufficient.
It may vary depending on the printer's tolerance. If it is too stiff, printing at around 101% should be sufficient.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
