Thingiverse
EX2H / Bugs 3 lightweight legs
door Bakashi
4
Downloads
2
Likes
0
Makes
Legs replacement to make the drone fit 500g limit (removed battery cover).
Should fit MJX Bugs 3 and Eachine EX2H
Hole size is 4mm so it's possible to use fiberglass rod as legs like with
https://www.thingiverse.com/thing:3098133
in my case though I tried to print screw like rods so they are detachable by unscrewing. Even if wobbly, they work good enough and camera never hit the ground
There is separate left and right side tilted so rods are not visible on stock camera (you need two of each)
Additionally left there my first attempts for legs in similar way that mentioned before thing:3098133 worked but rods were visible on recordings.
Should fit MJX Bugs 3 and Eachine EX2H
Hole size is 4mm so it's possible to use fiberglass rod as legs like with
https://www.thingiverse.com/thing:3098133
in my case though I tried to print screw like rods so they are detachable by unscrewing. Even if wobbly, they work good enough and camera never hit the ground
There is separate left and right side tilted so rods are not visible on stock camera (you need two of each)
Additionally left there my first attempts for legs in similar way that mentioned before thing:3098133 worked but rods were visible on recordings.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
