Thingiverse
Explorer 1 remix
by wanhaofan1
1
Downloads
3
Likes
0
Makes
Made some modifications to smilow's Explorer 1.
1. Sliced the nose off so it would fit in my printer's Z height.
2. Split up the sliced model into individual bodies so I could print the engine section and aft cylinder in white, and the forward cylinder and nose silver.
3. Made some "wires". Print these with 0.25mm height and 0.5mm width. They fit in the little holes in the forward cylinder.
4. Made an improved stand. The stand can be printed in one part if your printer is good with overhangs. I also include a version with the name plate split out. Neither require supports.
You'll also need the pin from the original model.
1. Sliced the nose off so it would fit in my printer's Z height.
2. Split up the sliced model into individual bodies so I could print the engine section and aft cylinder in white, and the forward cylinder and nose silver.
3. Made some "wires". Print these with 0.25mm height and 0.5mm width. They fit in the little holes in the forward cylinder.
4. Made an improved stand. The stand can be printed in one part if your printer is good with overhangs. I also include a version with the name plate split out. Neither require supports.
You'll also need the pin from the original model.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
