ExpressLRS 2.4 Tx Snap Fit Case

Update June 22, 2021: I added a second lid with the antenna connector to the right (looking from above). If needed, I guess it could be easily mirrored to the left in the slicer.

This is a Snap Fit JR Bay module for the Happymodel 2.4 TX for ExpressLRS. It is based on my previous design (which was based on Solidware) with the idea of getting rid of the very fragile tabs that went into the lid. Just like my previous design, there are holes for mounting the board with screws, but you can also use the upper spacer created by Ben Wilson:

https://www.thingiverse.com/thing:4867657

I printed the pieces in PETG. The tolerance between the body and the lid is 0.2 mm which works good in my printer, please let me know if you need adjustments.