Thingiverse
EXT Storia Compression Knob
4
Downloads
0
Likes
0
Makes
Didn't want to carry a 12 mm hex socket with me to adjust the high speed compression on my EXT Storia rear shock.
This is a snug fit - model size for the hex is 12.15 mm, it slides on and stays on, I wouldn't keep it there permanently, but this is small enough to fit in any pocket.
Printed in PETG at 0.2 mm resolution with 4 perimeters. Print upside down (handle on the bed), then it needs no supports.
This is a snug fit - model size for the hex is 12.15 mm, it slides on and stays on, I wouldn't keep it there permanently, but this is small enough to fit in any pocket.
Printed in PETG at 0.2 mm resolution with 4 perimeters. Print upside down (handle on the bed), then it needs no supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
