Thingiverse
Extension Rod Holders
von ivanhoeeewu
1
Downloads
2
Likes
0
Makes
Design the holders. Cater for a hole in the centre of the holder, to
drill in the screw, to secure the holder to the wall.
Then just insert the ends of the extension rods to the holders.
This rod is steady enough to hang a combination of 20 shirts and
pants/jeans.
Printer: #CraftBot
Slicer: #CraftWare
Extrusion width: 0.42mm
Layer height: 0.30mm
Layer height: 0.40mm
Infill
Type: Triangle
Density: 15%
Thickness: 3 lines
Vertical shell
Count: 5 loops
Thickness: 2.10mm
Raft offset: 10mm
Speeds:
Draw: 70mm/s
1st layer draw: 30mm/s
Travel: 70mm/s
Temperature
Head: 220 deg. C
Bed: 60 deg. C
drill in the screw, to secure the holder to the wall.
Then just insert the ends of the extension rods to the holders.
This rod is steady enough to hang a combination of 20 shirts and
pants/jeans.
Printer: #CraftBot
Slicer: #CraftWare
Extrusion width: 0.42mm
Layer height: 0.30mm
Layer height: 0.40mm
Infill
Type: Triangle
Density: 15%
Thickness: 3 lines
Vertical shell
Count: 5 loops
Thickness: 2.10mm
Raft offset: 10mm
Speeds:
Draw: 70mm/s
1st layer draw: 30mm/s
Travel: 70mm/s
Temperature
Head: 220 deg. C
Bed: 60 deg. C
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!