External Fan shroud for PC case(designed for Node 202)

This fan shroud is designed specifically for the Fractal design node 202 where there is a 140mm window. I needed to add another fan but there are no space left inside the case, so I mounted the fan on the outside, and use a 4-pin jumper/dupont cable to go through the gaps of the case and connect both the fan and the motherboard. I then use this cover to cover the 120mm fan and the rest of the space of the 140mm window, leaving a groove for cable management. I also added 4 holes at the bottom for magnets of 8mm diameter and 1mm height. I also left a bit of space on top for placing a 120mm fan filter.
**Print it with the honeycomb side on the build plate.** The measurements of everything are very tight, I would recommend scaling it up by a bit if your printer tends to print things smaller than they are supposed to be, like mine.
\* If you are also thinking to use it for the noctua fan, remember to remove the rubber corners on the cover side.

This object was made in Tinkercad. Edit i