Thingiverse
External Rayven Magwell
von Warchest
13
Downloads
14
Likes
0
Makes
Attempted, untested, thrown together, unrefined external rayven magwell.
In 2 parts so you can still open your shell once you epoxy or plastic weld this bad boi onto your blaster.
Give me feedback on this if you can, I want to know how long it stays on, or if it needs tweaking, if it can even fit mags through properly etc. Let me know.
Once done printing snap off the support boxes below the thin wall, as shown in the grey picture.
In 2 parts so you can still open your shell once you epoxy or plastic weld this bad boi onto your blaster.
Give me feedback on this if you can, I want to know how long it stays on, or if it needs tweaking, if it can even fit mags through properly etc. Let me know.
Once done printing snap off the support boxes below the thin wall, as shown in the grey picture.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
