Thingiverse
Extra330 static model
door aero330
87
Downloads
77
Likes
1
Makes
UPDATE 3 Sept 2016:
Added 2 different propellers
This is one of a series of static models that I made with my new Anet A8 3D printer.
Info:
Wingspan: 183mm
Length: 167mm
These are the steps to build your airplane:
- Install the wings into the fuselage by forcing them into the corresponding hole (probably you have to sand a little bit along the inner airfoil)
- Install the horizontal stabilizers
- Glue the forepart and the spinner w/ propeller to the fuselage
- Glue the landing gear
Done!
Added 2 different propellers
This is one of a series of static models that I made with my new Anet A8 3D printer.
Info:
Wingspan: 183mm
Length: 167mm
These are the steps to build your airplane:
- Install the wings into the fuselage by forcing them into the corresponding hole (probably you have to sand a little bit along the inner airfoil)
- Install the horizontal stabilizers
- Glue the forepart and the spinner w/ propeller to the fuselage
- Glue the landing gear
Done!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
