Thingiverse
Extreme Bow Stabilizer V2 - Customizable!
door myeh2k
104
Downloads
86
Likes
1
Makes
This bow stabilizer is the 2nd version of this one: https://www.thingiverse.com/thing:2458936
Improvements include:
- Better print-ability without supports.
- Smaller dimensions (less plastic = faster print)
- Improved slots for bolts
I wanted to create a simple bow stabilizer that is not only great looking, but also is functional. This version of the stabilizer will save you a lot of print time, and material. By using 4 used/old/found arrow shafts, and going to the store to buy a couple of parts, this project will cost you only about $5.
3D Parts needed:
- 1x Receiver (1.25" OR 2")
- Rail (Need 1. Print as many as you would like)
- 1x Barrel
- 1x Flash Hider OR Silencer (Optional, but it adds on to the looks of it.)
Parts required to assemble:
- 4x 7.8mm Arrow shafts
- 1x UNF 5/16*24 1.25" OR 5/16-24 2" bolt
- 1x M10 90mm
- 4x M10 nuts
Assembly instructions:
(Notice! You may need to use a 5/16" drill bit to expand the arrow slots. If too loose, use silicon
Improvements include:
- Better print-ability without supports.
- Smaller dimensions (less plastic = faster print)
- Improved slots for bolts
I wanted to create a simple bow stabilizer that is not only great looking, but also is functional. This version of the stabilizer will save you a lot of print time, and material. By using 4 used/old/found arrow shafts, and going to the store to buy a couple of parts, this project will cost you only about $5.
3D Parts needed:
- 1x Receiver (1.25" OR 2")
- Rail (Need 1. Print as many as you would like)
- 1x Barrel
- 1x Flash Hider OR Silencer (Optional, but it adds on to the looks of it.)
Parts required to assemble:
- 4x 7.8mm Arrow shafts
- 1x UNF 5/16*24 1.25" OR 5/16-24 2" bolt
- 1x M10 90mm
- 4x M10 nuts
Assembly instructions:
(Notice! You may need to use a 5/16" drill bit to expand the arrow slots. If too loose, use silicon
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
