Thingiverse
extruder calibration
door Cantankerous
3
Downloads
1
Likes
0
Makes
to calibrate esteps, its 120mm long with a step at 100mm
mark your filament at the tip which is 120mm and then use the step to check if 20mm remains after calibration, if its out measure with a ruler the difference and use maths to figure out your steps
mark your filament at the tip which is 120mm and then use the step to check if 20mm remains after calibration, if its out measure with a ruler the difference and use maths to figure out your steps
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!