Thingiverse
Extruder fan support
von 3D_Light_Lab
0
Downloads
0
Likes
0
Makes
This is my extruder fan support for the "turbocharger" fan as I call it and the air deflector.
You have to use this air deflector because the fan is quite low in order to have enough space for the lever for the filament change.
For the assembly I have used 2 screws for the support to the metal sheet and 2 longer screws and 2 nuts. On the left side there is not so much space to hold the nut, it's tricky but it's feasible.
You have to use this air deflector because the fan is quite low in order to have enough space for the lever for the filament change.
For the assembly I have used 2 screws for the support to the metal sheet and 2 longer screws and 2 nuts. On the left side there is not so much space to hold the nut, it's tricky but it's feasible.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!