Thingiverse
Extruder Spring Cup
por Riffraffs
246
Descargas
133
Likes
2
Makes
the spring on the Ender 3 allows filament to slip. This results in a 1st layer that does not print evenly. This adds about 2mm of extra tension to the spring. I had to put a 5mm drill bit in the center hole to ream out excessive plastic. If you feel more tension is needed use one at each end of the spring.
There is a new remix here https://www.thingiverse.com/thing:4815873 as well
There is a new remix here https://www.thingiverse.com/thing:4815873 as well
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
