Extrusion MMS (Manual Material System)

Manual “AMS” based on 20x20 extrusion. Thought a lot of the other models avaliable was too time consuming to print and offered little flexibility. This MMS is made to be easy to print, use minimal material, few parts and easy to expand if needed (as many slots you need)Parts needed: - 2X 20x20 extrusion. I used 45cm lenght. But this can be adjusted based on how many slots you need- 4 x 608 ball bearings pr slot. - M4-M5 fastening hardware (fastener and extrusion nut). I only used 10 fasteners and 10 nuts. - PTFE tubes- Splitter