Eye loupe case / box

Illuminated eye loupe case / box

Printer Settings
Infil 90% on Case and 10% on Lid
Perimeters = 3
Because the printer is only used occasionally; 3 perimeters ensures everything is flowing nicely before it starts to print the part.
Top Surface = 5
Not using any support material inside the case; 5 top surface layers allows for spanning the 'gap'. This creates a few 'stingy bits' to the underside (second photo inside case) but these can be cut out with a craft knife. The outside 'top' surface is good (third photo).
Bottom Surface = 3
Support material = off