EZABL Case for frame mounting

I have the Creality CR10 S5 and TDH's EZABL (Automatic Bed Leveling) kit. I wanted a way to mount it to the frame with T-Nuts so I created this case. The original case has 4 holes but I couldn't find a good place to mount it. I have the Direct Wire version.

Per Tim's instructions, to remove the circuit board from the current case you need to heat up the bottom of the case with a heat gun until the hot glue softens and you can remove the circuit board. This worked fine for me and softened up the sides of the case too so I could sort of peel them down to get a better grip on the board. I assume no responsibility if you damage your circuit board doing this. Just don't over heat it and you should be good to go.
It's a tight fit for the board so I didn't even bother using hot glue to secure it in the new case and since it's mounted on the frame there is very little movement.

I made the inserts for the lid screws pretty big but the actual holes small so you should be able find 2