EZR Extruder - Cable Guide

After installing my EZRstruder by SeeMeCNC, I wanted a small cable routing part to be installed on the front of the extruder using the preexisting screw holes. Here is what I made! Please see images for installation and print setup.

*All hardware used, other than zip tie, came with the EZR extruder.*

That said, here is the hardware used just in case:

2x M4 by 20mm
2x M4 Lock Nuts (Normal M4 nuts would work too)
1x Zip Tie (2.6mm x 1mm) *optional, but recommended.*

I hope this is useful!