Thingiverse
f Oculus Rift - Bee (DIY Oculus)
von spyfeedback
123
Downloads
130
Likes
2
Makes
Printable, FDM ready case based on the original open source oculus files.
Display: HDMI+VGA+2AV Controller Board+N070ICG LD3 LD4 7" TFT 1280*800 IPS LCD Display
Lens: 5x pocket loupe magnifier with Aspheric Lens
Tracker: I changed the Stm32F3Discovery board to Will1384's tracker, STM32F103C8T6 board with MPU-6000.
Link: http://www.mtbs3d.com/phpBB/viewtopic.php?f=26&t=19607&sid=29c914f93324217369fcf06aabec845e&start=80
This config is fully supported by the oculus runtime 0.4.4, all the newest games and all the third party drivers (VorpX, Tridef Ignition, Vireio Preception) like the original Oculus Rift.
The total weight of the HMD is 630 g besides the original DK1 which is 380g, but I fill the rear head piece with lead so its now weight ballanced and comfortable.
Have a good print and keep on riftin' !!! :)
Display: HDMI+VGA+2AV Controller Board+N070ICG LD3 LD4 7" TFT 1280*800 IPS LCD Display
Lens: 5x pocket loupe magnifier with Aspheric Lens
Tracker: I changed the Stm32F3Discovery board to Will1384's tracker, STM32F103C8T6 board with MPU-6000.
Link: http://www.mtbs3d.com/phpBB/viewtopic.php?f=26&t=19607&sid=29c914f93324217369fcf06aabec845e&start=80
This config is fully supported by the oculus runtime 0.4.4, all the newest games and all the third party drivers (VorpX, Tridef Ignition, Vireio Preception) like the original Oculus Rift.
The total weight of the HMD is 630 g besides the original DK1 which is 380g, but I fill the rear head piece with lead so its now weight ballanced and comfortable.
Have a good print and keep on riftin' !!! :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
