Thingiverse
F1 Front Wing Keychain
por JoshuaLotion
11
Descargas
42
Likes
0
Makes
Made a remix to turn this nice design into a keychain.
I printed at 0.2mm layer height. Its important to get good support height so it doesnt stick to the model too much. Might break off the wing when removing since its only 1 layer thick
I printed at 0.2mm layer height. Its important to get good support height so it doesnt stick to the model too much. Might break off the wing when removing since its only 1 layer thick
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
