F1 OpenRC tire Mold

Its a remix, just smaller to print it faster and earn some filament

1. Prepare 1:16 soapy water. Like in a a bowl. 3 or 4 cups of water and 1/4 dish easher soap.
2. Use the silicone gun and drop 4 hits of silicone in the soapy water.
3. Start doing some hand job and mix the silicone to get one piece. You will notice it start to get a bit harder. It takes about 1 or 2 minutes.
4. Try to always get your hands wet. So the silicone wont glue to your hand.
5. Make a roll of silicone and start introducind into the mold.
6. Press hard. So you can grt the water out and fill all the gaps in there.
7. Repeat again with the other half.
8. Join the 2 halfs
9. Use some press or i dont know how they named (clamps it is). Lol. But the machine to make presure on both sides. Lmao.
10. After an hour or 1.5 hours you can get the tire out.
11. Drop.the tire in the bowl with soapy water for 3 more hours. It acts like an activator.


Español
1. Preparar una mezcla de agua con detergente en