F150 Seat Release Version 2

This is a re-mix of my original design for releasing the rear drivers side seat in the crew cab model f-150. I'd suggest using petg or abs as the heat in the truck during the summers can be enough to deform PLA.

To install just remove the two torx screws, remove the bracket, put the hand through the printed part and put it on the pin for releasing the seat, then put the printed part down on top of the bracket. Re-install the bracket and replace the torx screws, and you have a seat release.

If you like the part and wish to contribute to my time designing this part please send any contributions to my paypal account.