F16 ICP V2 Baclight

MY Falcon4 BMS collection https://www.printables.com/@riccardoland_1626907/collections/2295948

Software and tools https://github.com/Bacon8tor/awesome-falcon-bms-tools

After building the TWP with 6x6x9 microswitches, I wanted to redesign the ICP along the same lines, using the microswitch's central pin as a support for the button itself, backlighting with LEDs, and using a 2.54-pitch multi-hole fiberglass board as a support.

So I redesigned the ICP.

The button bodies fit onto the 6x6x9 microswitches, while the two rockers still rest on 6x6x4.3 microswitches. To give the round buttons a sense of direction, I made a small notch. Some sandpaper is needed to smooth and round any protrusions and 3D printing features.

To secure everything, I used glue and 2mm or M2 screws, found in a kit on Amazon in various lengths, which are also very useful for securing Arduino and various interfaces.

The microswitches, as shown in the photo, must be aligned on the right side to center the pins wit