Thingiverse
F4i Switch Bracket v1
by camKuch
0
Downloads
0
Likes
0
Makes
Thank you for choosing my design.
Designed to be put in the rear subframe to relocate your KS and IGN along with 2 accessories.
Settings:
Use a high temp material that will be good in UV rays(ASA, ABS, PC, PETG)
Infill 100%
Slow speed for good adhesion - I go 50mm/s
No Supports
Large Hole is at 25.5mm
Small Holes at 21.5mm
Currently designing a v2 that will be put in the right or left side of the airbox where the air ram is routes from. That location has much more room and is way closer to the wiring harness you need to access.
Link to the switches used:
https://www.amazon.com/dp/B09BDCCM29?ref=ppx_yo2ov_dt_b_fed_asin_title
https://www.amazon.com/dp/B07SGWXB3P?ref=ppx_yo2ov_dt_b_fed_asin_title
Designed to be put in the rear subframe to relocate your KS and IGN along with 2 accessories.
Settings:
Use a high temp material that will be good in UV rays(ASA, ABS, PC, PETG)
Infill 100%
Slow speed for good adhesion - I go 50mm/s
No Supports
Large Hole is at 25.5mm
Small Holes at 21.5mm
Currently designing a v2 that will be put in the right or left side of the airbox where the air ram is routes from. That location has much more room and is way closer to the wiring harness you need to access.
Link to the switches used:
https://www.amazon.com/dp/B09BDCCM29?ref=ppx_yo2ov_dt_b_fed_asin_title
https://www.amazon.com/dp/B07SGWXB3P?ref=ppx_yo2ov_dt_b_fed_asin_title
camKuch also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
