Fabric Bow Making Aid

This is a tool to help with making consistent sized bows. The different arms in the design allow you to create different sized bows depending on your needs. The hole in the middle is to allow for the center wrap of the bow to help hold it together. All prints were done with PLA, but any filament should work fine. It is printed with a brim to help with bed adhesion because of the thin nature of each of the arms. Start with putting the ribbon in the middle holders.Pick a pair of teeth and wrap it around them:Bring the ribbon from the top down through the large hole:Tie in the middle.Different sized ribbon create different results. The design of this tool is based on an old Youtube Video below, it walks through the process of tying in case it is not clear from the images.