Face mask fitter

3D print mask fitter (PLA only)

The masks that we wear protect against germs only about 38.5% from the research results referenced below.
More than 70% of the protection required a 3D-printed mask-fit mask, with the model being scanned with a face-scanning iPhone model.

But not everyone has access to the face scanning system.

So I tried and designed a new mask to make it accessible to everyone. It's a design for everyone. New must be designed specifically. There are sizes s m l xl
By allowing the mask to adjust to its own face shape from hot forming, just by soaking in hot water. can bend the mask to fit your face
Curved design to match the shape of the face and chin, nose. Design of fasteners to hold both normal rubber bands. Round or flat mounting rubber Tried it and it works fine.
How to use
All you have to do is dip it in hot water for about 2 minutes and bring it up quickly. Place it on your masked face. There will be a little residual heat here if you If you are