Thingiverse
Face Shield - M-SARS
door Creative-Process
3
Downloads
9
Likes
0
Makes
Edit:
V5 - for Form3, Phenom etc.
V4 - for Form2 (10 mm shorter)
This is a Face Shield design that can be printed on all Resin 3D Printers which have at least a Print-Size of 141 mm X or Y and Z of 185 mm (M-SLA, DLP, SLA) .
It suits the Form 2 perfectly. It can be printed up to 17 frames at ones in ~15h.
Since the prints are cleaned in IPA and curing in UV, they can be considered sterile. They also withstand boiling water and most chemicals.
The foils are clear binding covers in A4. For the holes you can use the template.pdf or make your own be using a ISO 838 hole punch. I recommend using a hand operated single hole punch, otherwise you produce additional holes in the foil.
The burr aka elephant foot doesn't interfere with the function, but can be removed with a knive.
(M-SARS = Masked - selective applied ray sintering)
V5 - for Form3, Phenom etc.
V4 - for Form2 (10 mm shorter)
This is a Face Shield design that can be printed on all Resin 3D Printers which have at least a Print-Size of 141 mm X or Y and Z of 185 mm (M-SLA, DLP, SLA) .
It suits the Form 2 perfectly. It can be printed up to 17 frames at ones in ~15h.
Since the prints are cleaned in IPA and curing in UV, they can be considered sterile. They also withstand boiling water and most chemicals.
The foils are clear binding covers in A4. For the holes you can use the template.pdf or make your own be using a ISO 838 hole punch. I recommend using a hand operated single hole punch, otherwise you produce additional holes in the foil.
The burr aka elephant foot doesn't interfere with the function, but can be removed with a knive.
(M-SARS = Masked - selective applied ray sintering)
Creative-Process publiceert ook op
19 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
