Slicer Discord
Face Soap Stamp – Modelo 3D imprimible de Thingiverse Thingiverse

Face Soap Stamp

por emikanj2
18 Descargas
19 Likes
0 Makes
Ver Modelo
Got tired of TSA pulling my smooth and non-descript bars of facial soap out of my bags and asking me what it was and testing for gunpowder residue. The whole point of using a bar of soap was that I didn't have the hassle of traveling with liquids.

Here is a stamp that will clearly label a square bar of soap with the words "Face Soap". The stamp is meant for a bar about 8 by 8 cm, but could also work for most LUSH square bars. If you get the imprint deep enough (2-3mm) it can be read as the soap goes through an X-ray scanner, though be warned too much pressure may break the soap into pieces, especially if it is a brittle bar.

I would recommend at least 30% infill, though you could get away with less, it just makes the stamp and words less durable.
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Lijado
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección