Thingiverse
Fällkniven DC4 holder
von Jelle548
7
Downloads
7
Likes
0
Makes
The holder
Designed to make it easier and safer to hold the Fallkniven DC4 stone while sharpening a knife. The holder is also equipped with 2 20-degree angles as a reference during sharpening. To simplify the printing process, the holder consists of two halves that can be attached to each other with 3 pegs (no glue required, just some gentle hammer persuasion).
The storage sleeve
This sleeve is meant to store the DC4 together with the holder (and optionally the stropping plate and/or Fallkniven leather DC4 pouch) as a compact unit, as the DC4 is intended to be carried as a field sharpener.
The stropping plate
This is an optional print as a supplement to the DC4. The stropping plate is covered with approximately 3mm thick veg tanned leather and loaded with stropping compound of your choice.
Designed to make it easier and safer to hold the Fallkniven DC4 stone while sharpening a knife. The holder is also equipped with 2 20-degree angles as a reference during sharpening. To simplify the printing process, the holder consists of two halves that can be attached to each other with 3 pegs (no glue required, just some gentle hammer persuasion).
The storage sleeve
This sleeve is meant to store the DC4 together with the holder (and optionally the stropping plate and/or Fallkniven leather DC4 pouch) as a compact unit, as the DC4 is intended to be carried as a field sharpener.
The stropping plate
This is an optional print as a supplement to the DC4. The stropping plate is covered with approximately 3mm thick veg tanned leather and loaded with stropping compound of your choice.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
