Falcon Heavy Rocket Launcher

What it is: Its a little Rocket Launcher Toy in an Falcon Heavy Design! You simple hammer the button and the rocket flies up through the air pressure. The button is spring loaded with a easy printable spring.     The tower is only decorative, i tried to look similar to the SpaceX tower: Real vs Model 😊   Printing: I printed all parts in PLA+ but other materials could work better like the spring in PETG. Try and share your knowledge. No support needed! Your Printer need an good accuracy for the button and the rocket! They should fit nicely and seal a bit. But they should not clamp! With my X1 Carbon it turned out well. Scale the rocket and the button a little bit (<1%) if they are to tight or to lose.   Assembly: Print in Colors you like most👌New Spring design, assemble as shownInsert the spring and press the tower in the base.   Load Rocket and Button. You could add a bit of grease into the push button to seal it better.👍   Check the accuracy of your print, if you can get it smooth like that, the rocket flies very good!       Commercial license you can get here: https://www.patreon.com/BamBamDesign/membership