Thingiverse
Faller car system Hallsensor/Sensor Mount
door Zemizz
13
Downloads
6
Likes
0
Makes
It's designed for easier installment (and replacement) of hallsensors for the faller car system or any other car system.
The cap is permanently glued in a 8,5mm hole in a gap between two ends of the magnet band or car system wire. For the best results make sure to install the cap flush into the road surface.
The sensor, with wires attached to it, is glued on top of the screw (the wires can be run through the hole).
The cap is permanently glued in a 8,5mm hole in a gap between two ends of the magnet band or car system wire. For the best results make sure to install the cap flush into the road surface.
The sensor, with wires attached to it, is glued on top of the screw (the wires can be run through the hole).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
