Fallout Board Game enemy tile markers

Updated 6/13/2020: increased the size of the font for the numbers (3 and 4 weren't printing well enough); added versions with 1 2 3 instead of 01 02 03.


I kept losing track of which enemy spawned on what tile while playing the Fallout Board Game so I tried to make a stand for the enemy tokens that wouldn't damage the cardboard while inserting the enemy token. (inner edges are rounded a bit)

The rear "tooth" should be tall enough to allow you to pick up the token and the stand at the same time. The front "teeth" should be low enough to not cover the right-side attributes of the enemy and wide enough apart to not hide the leg vulnerability of enemies.
(The enemy token may lean forward a little but it shouldn't fall over)

The tokens looked to be about 2.1-2.2mm thick (my tool isn't that accurate) so i made the gap between the teeth 2.25 to give it room to sit as well as compensate for smooshed printing (i have a tendency to print low so the filament gets wider than it should b