Slicer Discord
Fallout Flash bangs (Mussy Design) – 3D printable model from MakerOnline MakerOnline
Fallout Flash bangs (Mussy Design) – Bild 1 Fallout Flash bangs (Mussy Design) – Bild 2 Fallout Flash bangs (Mussy Design) – Bild 3 Fallout Flash bangs (Mussy Design) – Bild 4 Fallout Flash bangs (Mussy Design) – Bild 5 Fallout Flash bangs (Mussy Design) – Bild 6
Hobby&DIY

Fallout Flash bangs (Mussy Design)

258 Downloads
57 Likes
0 Makes
Go to Model
FALLOUT CANISTER AND MINI NUKE FLASH-BANGS This is an IMPACT ACTIVATED flash bang that uses the 9mm X 21 blank rounds, !!! I TAKE NO RESPONSIBILITY IF YOU BLOW YOUR FINGERS OF !!! Enjoy 0.2 layer height 5-6 shells @ 5% infill should be enough NOTE: THESE GRENADES SPLIT IN HALF ON DETONATION SO AS TO MINIMIZE FRAGMENTS AND INJURY ! (The shell holder is disposable and can not be used after detonation) DON'T FORGET TO CHECK OUT MY OTHER KOOKOO DESIGNS !
Category
Hobby&DIY
Source
MakerOnline
Published
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

Dr.Mussy also publishes on

96 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection