Thingiverse
Fallout Red Rocket Sign
by Jeoncs
459
Downloads
493
Likes
2
Makes
Made this using Rhino and a bit of tinkercad. Printed the face plate with adaptive layer height .08-.28 and the rest at .28. Glued the letters into the sockets with super glue. Used double sided tape on the LED strips but I made holes so it could be zip tied or twist tied easily. LED strip is a cheap remote set from Walmart. I used M3 screws for fastening it all together but it should be fine to glue.
7/1/2019 - Added an all brick version of the frame. Same letters should work and the assembly should all work about the same. The back will just glue on for this one.
7/1/2019 - Added an all brick version of the frame. Same letters should work and the assembly should all work about the same. The back will just glue on for this one.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
