FAN FILTER (Built For Flsun SR)

DISCLAIMER: Make this upgrade at your own risk, always do your research and make sure to solder in a well ventilated area and always make sure to have the power turned off on the printer before installation!!!Description: Cover and magnets are optional since the filter is friction fit into the case. Uses the Noctua 80mm fan as well as the included screws to mount the fan to the case. Uses M3 screws for the handle and for the back plate. Parts list at the bottom!Everything is built to be compatible with my enclosure. Link here: https://www.printables.com/model/405015-flsun-sr-enclosure Instructions:You only need 1 ring for good lighting (but I used two since the lights come in a pack of 2), the print uses at least 2 M4x8 screws for mounting each of the lights.The BoardNotice below that the board that my Flsun SR came with is the robin nano v3.1. However, some SR's may not use this board so make sure you do your research to see what type you have what connector type you need. For thi