Fan Mount Tevo Tarantula Pro

I recently installed drivers Tmc2208 in my Tevo Tarantula Pro as they are hotter than the factory drivers, I need more airflow to cool them

As a solution, model this base that adapts perfectly to the internal dimensions of the case.

Necessary materials:
2 x 4010 Fans at 24v or 12v
12 x M3 X 20MM Screws
12 x M3 nuts
2 x M3 x 8mm screws

For the installation, you must follow the following steps:
1.- Remove the electronics box from the printer body
2.- remove the lower cover
3.- Remove the side fan
4.- Weld the power cables in parallel if they are 24 v, in case of using 12 v fans they must be welded in series
5.- Fix the fans in the corresponding windows using the m3 screws and nuts
6.- install the previously printed base with the fans mounted
5.- connect the cables of the fans to the outputs of the switched source of the printer that are not used