Thingiverse
Fan Rivet
von Hazel273
4
Downloads
3
Likes
0
Makes
A little nub to replace the screws in PC case fans to reduce noise and simplify assembly.
Pull the sharp end through the fan hole and then the flat end through the metal sheet, there is a small gap on that end that should hold onto the metal sheet. Wiggling around helps to get a good mount.
Solidworks file is from the 2017 version
Pull the sharp end through the fan hole and then the flat end through the metal sheet, there is a small gap on that end that should hold onto the metal sheet. Wiggling around helps to get a good mount.
Solidworks file is from the 2017 version
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
