Thingiverse
Fanatec DD desk mount
door stevegek
3
Downloads
9
Likes
0
Makes
Two M12 and 3 M6 (4cm long) screws are needed, and you need to drill holes in your desk. Putting it in place and removing it takes 30 seconds, and I hide the 2 holes with 2 plugs + a huge mousematt and keyboard on top.
SUPER solid. Thoroughly tested!
[Added 13/7/23] - Left and right version added for printers with a 20X20 build plate or larger. Be sure to download all 4 files indicating either LEFT or RIGHT. There is over .25 margin between the two parts, should be enough, I advice to add Bison Kit or other strong glue on the lower part of the edge, when its 50% dry (after 10-20 min?) mount to base. No glue should be able to touch the base. After its cured, remove plate and fill the rest of the gap (top side where the base will be). Clean it up, and let it dry. Should be rock solid.
SUPER solid. Thoroughly tested!
[Added 13/7/23] - Left and right version added for printers with a 20X20 build plate or larger. Be sure to download all 4 files indicating either LEFT or RIGHT. There is over .25 margin between the two parts, should be enough, I advice to add Bison Kit or other strong glue on the lower part of the edge, when its 50% dry (after 10-20 min?) mount to base. No glue should be able to touch the base. After its cured, remove plate and fill the rest of the gap (top side where the base will be). Clean it up, and let it dry. Should be rock solid.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
