FAST ABS FIRST LAYER TEST with Pull Lash (20 Min)

This is a fast first Layer Test to adjust flow rate, offset etc. I added a pull of lash that can help with easier removing of the first layer. The print takes 20 Minutes so its a fast calibration preset for ABS. Disclaimer: If your using srong glue + dont have time to wait for the plate to cool down the adhesion will bet too strong for the lash to work. If you dont have time to wait for it to cool down hold the Plate under some cool water and it will peel off easily. Use the Bambu Wiki to make changes after identifying your Layer Results on https://wiki.bambulab.com/en/knowledge-sharing/identify-and-fix-first-layer-issues-with-a-test-print Happy Testing !