Thingiverse
Fast and serious support test
door phildc
0
Downloads
1
Likes
0
Makes
To quickly test your support parameters.
Use it at its minimal size, or enlarge it.
SUGGEST minimum 250% to remove supports with normal size tools (depending on support parameters)
Can also be used to test an interface support layer of another material (e.g. PETG between a PLA object and the supports in the same PLA).
This can work without purge tower, and with minimal filament waste and a limited number of movements. Tested with Orca slicer.
Use it at its minimal size, or enlarge it.
SUGGEST minimum 250% to remove supports with normal size tools (depending on support parameters)
Can also be used to test an interface support layer of another material (e.g. PETG between a PLA object and the supports in the same PLA).
This can work without purge tower, and with minimal filament waste and a limited number of movements. Tested with Orca slicer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!