Thingiverse
Fastenal storage bin inserts
door DockGuy
5
Downloads
4
Likes
0
Makes
[https://www.printables.com/model/35701-fastenal-storage-bin-inserts]
I bought a bunch of these [Fastenal/TruForce 0569279 4.125" x 5.325" x 3" storage bins](
https://is.gd/vK0sWE) but forgot to get inserts to separate out small parts. So I designed inserts to fit.
These two inserts are not intended to be used together in the same bin. Use one or the other. I may update the models with notches to allow interlocking the two inserts at a later time or feel free to remix.
The inserts are approximately 1.25" high. You can scale the y-axis to make them a bit taller but if you go too tall, the fitment will be off since the interior of the bin has no right-angles.
I bought a bunch of these [Fastenal/TruForce 0569279 4.125" x 5.325" x 3" storage bins](
https://is.gd/vK0sWE) but forgot to get inserts to separate out small parts. So I designed inserts to fit.
These two inserts are not intended to be used together in the same bin. Use one or the other. I may update the models with notches to allow interlocking the two inserts at a later time or feel free to remix.
The inserts are approximately 1.25" high. You can scale the y-axis to make them a bit taller but if you go too tall, the fitment will be off since the interior of the bin has no right-angles.
DockGuy publiceert ook op
81 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
