Thingiverse
Fate Dice
by Bruckard
5
Downloads
6
Likes
0
Makes
A very quick and simple fudge dice (+, +, -, -, blank, blank). They are designed to be used with roleplaying systems like the awesome Fate system: http://www.faterpg.com/. The indents can be a bit hard to see, so I now use white PLA and fill in the lines with a fine point permanent marker (the colour often bleeds a bit). As they are hollow, I also like to drop a small round bell into them as they are printing. It gives the dice a bit more weight, more randomness and a nice sound.
I use this as a test cube for my printer (if it works I have a new dice, if it doesn't I can see where it went wrong.) They often come out about half a mm off in height and width. They use about 1gram of filament and take about 10minutes to print.
The native scale is very small, but I have printed it from 10mm to 22mm without issue.
I have used PLA to print this at 0% infill at 200degree on a 60degree bed, without any support or brim. I often print 4 at a time.
I have added a second file, w
I use this as a test cube for my printer (if it works I have a new dice, if it doesn't I can see where it went wrong.) They often come out about half a mm off in height and width. They use about 1gram of filament and take about 10minutes to print.
The native scale is very small, but I have printed it from 10mm to 22mm without issue.
I have used PLA to print this at 0% infill at 200degree on a 60degree bed, without any support or brim. I often print 4 at a time.
I have added a second file, w
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
