Thingiverse
FDL3 Tacticool Shorty Kit
von Lyzaaa
5
Downloads
1
Likes
0
Makes
A longer version of the FDL3 shorty barrel for stefan darts!
I remixed this from the original FDL3 by Jesse and Jackie over at Project FDL, because i wanted a longer look for the FDL and because i shot myself in the finger while holding it.
Just a few extra screws is needed for this kit, and the side rails might need to be glued in as well, because it only has one screw port and it would swivel. (A little too busy to revise this because i'm working on other stuff, honestly. Sorry!)
Reduces the overall FPS at max speed to 160fps from 180fps, but increases overall accuracy. This is just a disclaimer, results may vary.
Print settings as per normal, 3 walls 15% will be enough since this is a flywheeler, and temperatures as according to your own material choosing.
I remixed this from the original FDL3 by Jesse and Jackie over at Project FDL, because i wanted a longer look for the FDL and because i shot myself in the finger while holding it.
Just a few extra screws is needed for this kit, and the side rails might need to be glued in as well, because it only has one screw port and it would swivel. (A little too busy to revise this because i'm working on other stuff, honestly. Sorry!)
Reduces the overall FPS at max speed to 160fps from 180fps, but increases overall accuracy. This is just a disclaimer, results may vary.
Print settings as per normal, 3 walls 15% will be enough since this is a flywheeler, and temperatures as according to your own material choosing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
