Feather Board with additional cross bars

This is a remix of the amazing high quality feather board designed by https://makerworld.com/en/@user_3257010834 This was the best one I could find out there. I liked this design a lot, but I just felt it could be a little safer considering it was so open in the middle. I added 2 simple cross bars diagonally to add more rigidity in case of a kickback. I also added a few modifiers to the frame and the thin rip guide pieces. I used honeycomb infill at 25% for strength. On the frame, the modifier ups the infill to 50% around the areas where the teeth attach since that area is a bit thinner. I also upped the infill to 50% on the thin rip guide pieces. The teeth are done in TPU for flexibility. I did these with 20% infill using triangles. If you want them to be softer or stiffer, just change the infill % higher or lower in Bambu Studio. I found 20% good for my taste. I just used cheap Jayo brand TPU for mine and they turned out perfect. I also made these at 101.5% scale to the original for